Changeset 3429 for LMDZ6/branches/Ocean_skin/libf/phylmd/conf_phys_m.F90

Timestamp:

Jan 2, 2019, 7:44:20 PM (6 years ago)

Author:

lguez

Message:

Create subdirectory Ocean_skin in libf. For now, Ocean_skin is under
control of git, not subversion.

Add variable eps_w to common YOMCST.

For now, continue to read ocean skin parameters from a namelist in
config_ocean_skin.

The parameterisation is called from procedure surf_ocean.

Add two prognostic variables for the parameterisation: dt_ns and
ds_ns. Add eight diagnostic variables: t_int, s_int, dter, dser, tkt,
tks, rf, taur. The ten variables are only defined on ocean surface,
elsewhere they are set to nf90_fill_real. In pbl_surface, we can
initialize the eight diagnostic variables to nf90_fill_real before the
loop on sub-surfaces, but we need to keep the old values of dt_ns and
ds_ns as input of the parameterisation so we set dt_ns and ds_ns to
nf90_fill_real after the call to surf_ocean. Define ten corresponding
compressed variables in pbl_surface. Define ten corresponding NetCDF
output variables in phys_output_ctrlout_mod.

In procedure pbl_surface_newfrac, for an appearing ocean sub-surface,
dt_ns and ds_ns are set to 0. In phyetat0, also set initial dt_ns and
ds_ns to 0 if they are not in start file.

In procedure surf_ocean, for now, we use a constant specific latent
heat of vaporization, as elsewhere in LMDZ, and a constant bulk
salinity.

File:

• LMDZ6/branches/Ocean_skin/libf/phylmd/conf_phys_m.F90 (modified) (2 diffs)

LMDZ6/branches/Ocean_skin/libf/phylmd/conf_phys_m.F90

@@ -29 +29 @@
     USE mod_grid_phy_lmdz, ONLY: klon_glo
     USE print_control_mod, ONLY: lunout
+    use config_ocean_skin_m, only: config_ocean_skin
 
     INCLUDE "conema3.h"
@@ -2170 +2171 @@
     CALL getin('level_coupling_esm',level_coupling_esm_omp)
     ! << PC
+
+    call config_ocean_skin
 
     !$OMP END MASTER